帮助 本站公告
您现在所在的位置:网站首页 > 知识中心 > 文献详情
文献详细Journal detailed

高导热低黏度环氧树脂灌封胶
Epoxy Potting Adhesive with High Thermal Conductivity and Low Viscosity

作  者: ; ; ;

机构地区: 合肥工业大学化学工程学院

出  处: 《化学与粘合》 2013年第6期16-18,35,共4页

摘  要: 以E-51型环氧树脂为基体,Al2O3为导热填料,CYH-277为稀释剂制备高导热低黏度环氧树脂灌封胶。优化了硅烷偶联剂KH-560、稀释剂CYH-277的用量;分别采用NDJ-7型旋转式黏度计和Hot Disk型热常数分析仪测试其黏度和导热系数。结果表明:硅烷偶联剂KH-560用量为1.25%(wt)时效果最优;随CYH-277用量的增加灌封胶黏度、耐热性能均逐渐下降,最佳用量为25%(wt);随Al2O3用量增加,灌封胶的黏度、导热系数均增大;用量相同时,填充20μm Al2O3的树脂体系相比于填充6μm Al2O3树脂体系黏度小、导热系数大,复配两种粒径Al2O3对应树脂体系的导热性最好;复配Al2O3用量为86%(wt)时,导热系数达到2.23W/(m·K),此时灌封胶的黏度为30100mPa·s,仍保持较好的加工流动性。 An epoxy potting adhesive with high thermal conductivity and low viscosity was prepared with using E-51 epoxy resin as a matrix,Al2O3 as a thermally conductive filler,and CYH-277 as a diluent.The amount of coupling agent and diluent were optimized.The viscosity and thermal conductivities of the epoxy potting adhesive were investigated by NDJ-7 rotation viscometer and Hot Disk thermal constant analyzer.The results showed that the best dosage of KH-560 was 1.25%(wt).The viscosity and heat resistance both gradually declined with the increasing dosage of CYH-277 and the best dosage was 25%(wt).The viscosity and thermal conductivity both rose with the increasing content of Al2O3.when the filler content was same,the 20μμm Al2O3 was beneficial to a higher thermal conductivity and a lower viscosity than the 6μm Al2O3. Compared with single Al2O3 filled composite,it was found that the hybrid Al2O3 filled composite had higher thermal conductivity.When the filling fraction of hybrid Al2O3 was 86%(wt),the thermal conductivity reached 2.23W/(m·K) and the viscosity was 30100mPa·s,which showed high thermal conductivity and good flow properties.

关 键 词: 环氧树脂 导热系数 灌封胶 黏度

领  域: [化学工程]

相关作者

作者 尹应梅
作者 葛艳

相关机构对象

机构 中山大学
机构 广东工业大学

相关领域作者

作者 余琳
作者 刘洋
作者 何慧
作者 危旭芳
作者 张振刚