作　　者： ; ;

机构地区： 内蒙古科技大学机械工程学院

出　　处： 《包钢科技》 2013年第3期53-55,共3页

摘　　要： 考虑到轴承刚度的影响,建立弹性支撑的有限元模型,利用有限元方法分析得出了电主轴在弹性支撑下的各阶固有频率和相应的阵型。进一步考虑了电主轴安装不同数目刀头的因素,对电主轴进行了谐响应分析,绘制电主轴3个方向的频率-振幅曲线。根据简谐力作用下的振动分布情况,可以看出在固有频率处电主轴在简谐力的作用下动刚度较差,在加工工作中频率应尽可能的避免会产生振动位移波峰的固有频率。 Due to the effects of bearing rigidity, the finite element modle of elastic support is established as well as the natural frequency and relative formation of each order for motorized spindle with elastic support are obtained by analysis with finite element method. Fur[hermore, since the number of tool bit for motorized spindle is different, the harmonic response a- nalysis of,motorized spindle is made ：and the curves of frequency - amplitude for three directions of motorized spindle are drawn. Based on the situations of vibrational distribution with harmonic force, the dynamic stiffness of motorized spindle is not good at the position of natural frequeny Thus,the natural frequency which could cause peak of vibration displacement should be avoided as far as possible in proeessingr

关 键 词： 电主轴 弹性支撑 谐响应 共振

领　　域： [金属学及工艺]