作　　者： ; ; ; ; ; ;

机构地区： 大连理工大学材料科学与工程学院

出　　处： 《功能材料》 2010年第6期1005-1007,1011,共4页

摘　　要： 为了提高钛表面的生物活性,利用微弧氧化工艺分别在普通粗晶钛和表面高能喷丸细晶钛上制备了多孔TiO2氧化层。经光镜和透射电镜观察,喷丸钛表面形成厚度>40μm,直径100～200nm的等轴晶结构层。利用扫描电镜(带能谱分析)和X射线衍射仪对氧化层表面形貌、成分和相组成进行分析。结果表明,高能喷丸钛的表面生成的氧化层中含有α-Ca3(PO4)2相且钙磷百分含量提高。在粗糙的高能喷丸钛表面,微弧氧化速度在不同位置有所不同,氧化层与基体形成微机械咬合,基层结合力提高。 To improve the bioactivity of Ti surfaces,porous titania coating were prepared on the high-energy shot peenig treated（HESP） and commercial pure（CP） titanium by micro-arc oxidation（MAO）.By OM and TEM observation,the equiaxed grain structural layer with thickness of about 40 μm and diameter of 100-200nm formed on the HESP titanium surface.The phase identification,thickness,composition and morphology of the coating were analyzed by X-ray diffraction,Scanning electron microscope equipped with energy-dispersive X-ray spectroscopy.The amounts of Ca,P and Ca/P ratio of the MAO coating formed on the HESP-treated Ti were higher than those of CP Ti obviously.The α-Ca3（PO4）2 phase appeared in H10 MAO coating.Due to surface roughness of HESP Ti increased,the oxidation rate is different in different locations,which leads the micro-mechanical occlusion and cohesion improvement between substrate and coating.

关 键 词： 高能喷丸 微弧氧化 钛 生物活性

领　　域： [一般工业技术] [一般工业技术]