作　　者： ; ; ; ; ;

机构地区： 中南大学材料科学与工程学院

出　　处： 《中国有色金属学报》 2004年第7期1188-1194,共7页

摘　　要： 采用硬度、电导率测试、DSC热分析及TEM观察等手段,研究了回归再时效处理对一种新型低频电磁铸造超高强铝合金组织与性能的影响。研究发现:合金在120℃时效24h后具有较高的硬度和强度水平。合金合宜的回归再时效处理工艺为120℃、24h预时效,180、60min回归,之后120℃、24h再时效。在此条件下,合金的抗拉强度、屈服强度、延伸率和电导率(IACS)分别为721MPa、700MPa、8.1%和34.5%。TEM观察表明:回归再时效过程中合金性能的变化与其微观组织的演变密切相关;回归初期,GP区和η′相的回溶导致合金硬度下降;随后,η′和η相的析出使硬度重新上升至峰值;最后,η′相转变成η、以及η相粗化引起硬度单调下降;再时效后析出的η′相提高了合金的强度、硬度和电导率。 The effect of Retrogression and re-ageing treatments on the microstructure and properties of a new type low frequency electromagnetic casting ultra-high-strength aluminum alloy were investigated using hardness and electric conductivity tests, DSC analysis and TEM observation. It is found that after ageing at 120 ℃ for 24 h, the studied alloy can gain high hardness and strength. After pre-ageing at 120 ℃ for 24 h, retrogression at 180 ℃ for 60 min, and then re-ageing at 120 ℃ for 24 h, the tensile strength, yield strength, elongation and electric conductivity(IACS) of the studied alloy are 721 MPa, 700 MPa, 8.1% and 34.5% respectively. The TEM observation shows that the property changes of the alloy during RRA are closely related to the microstructural evolution. In the early stage of retrogression, the re-dissolution of GP zone and η′ leads to the decrease of hardness, while precipitation of η′ and η makes hardness increase again to a peak value. Then, the transition of η′→η and coarsening of η lead to the decrease of hardness. Precipitation of η′ after reageing increases the hardness, strength and electric conductivity of the studied alloy.

关 键 词： 电磁铸造 超高强铝合金 微观组织 性能 处理

领　　域： [金属学及工艺] [金属学及工艺] [一般工业技术] [金属学及工艺]